Follow the steps to understand how to correctly install and connect BSMon v3.0.


  1. Get the special multicore cable and connect it to the BSMon unit and to the CBA unit, matching the proper side.


  1. Be sure to tighten the screws to lock the cable for power and signal consistency.


  1. At this point plug the USB cable into the USB socket of the main unit and connect the other end to the PC: the system will auto detect the interface and will automatically load the proper drivers in the system.


  1. The green LED on the CBA unit will turn on to confirm that the unit is properly connected


  1. After the system is installed, the battery can be installed on the V-Lock interface of the BSMon unit.

  2. In case there is need to test a non V-lock battery, get a proper cable ending with banana plugs on one end, and with proper terminals on the other for connecting with the battery terminals. Connect it to the BSMon unit to start reading. As for the cable length, shorter is better.


To troubleshoot connection problems, please refer to this section


Only the second generation of Blueshape® batteries can be analyzed with this version of BSMon. Read here to understand how to recognize the battery version